Figure 99. Installing the M.2 BOSS module
Next steps
1. Replace the BOSS card.
NOTE:
Replacing the BOSS card is similar to the procedure for installing an expansion card.
2.
Replace the expansion card riser
3.
4.
5. Follow the procedure listed in
After working inside your system
Optional IDSDM or vFlash module
NOTE:
The write-protect switch is on the IDSDM or vFlash module.
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in
.
2. Follow the procedure listed in
Before working inside your system
3.
.
4.
5.
Remove the expansion card riser
.
6.
Remove the IDSDM or vFlash module
Steps
1. Locate the MicroSD card slot on the IDSDM or vFlash module, and press the card to partially release it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
2. Hold the MicroSD card and remove it from the slot.
132
Installing and removing system components
Содержание PowerEdge R940xa
Страница 15: ...Figure 9 Configuration and layout Figure 10 Express service tag PowerEdge R940xa system overview 15 ...
Страница 17: ...Figure 13 Rear view configuration Figure 14 Jumper settings PowerEdge R940xa system overview 17 ...
Страница 19: ...Figure 18 Electrical overview PowerEdge R940xa system overview 19 ...
Страница 119: ...Figure 86 Installing the X8 PCIe Riser 1 Installing and removing system components 119 ...