DELEX DSI ES8300, Инструкция по установке и эксплуатации

Страница: 27 / 39

27
DESIGNED SECURITY INC 800-272-3555 www.dsigo.com
1402 Hawthorne Street Bastrop, Texas 78602 Fax 512 321 9181
Email: dsi@dsigo.com
INS8300
SENSOR ALIGNMENT
If necessary, you may adjust Sensor alignment by applying a slight twist and/or bend to the
sensor bracket until the sensor reflects directly off the opposing reflector.
Check for Alignment by following these steps:

Enable Bypass mode by shorting the Bypass Input terminals.

Apply Power to the lane. Barriers should remain stowed when powered in Bypass mode.

Cover any Reflector which may be mounted beside the one you are aiming for. Primarily on “A” and
“B” Sensors.

Adjust Sensor bracket for a good signal lock. LED Off indicates the
Sensor is in alignment with the Reflector and in a stable operating
state. (Lock indication)

For fine tuning, cut a penny-sized hole in a card and center the hole on
the Reflector you are aligning to.

Total of 8 Sensors.

For proper operation, each sensor must detect the light from its opposite reflector.

Using the above method will allow you to verify that you are not sensing a signal from another
reflector due to misalignment.

Repeat for each Sensor.

Remove the Bypass Input. Barriers should Cycle and stop extended across the lane. If the Barriers
do not move, or if there is an Alarm, replace the Bypass Input, and repeat the above steps.