13
DESIGNED SECURITY INC
800-272-3555 www.dsigo.com
1402 Hawthorne Street Bastrop, Texas 78602 Fax 512 321 9181
Email: [email protected]
INS8300
PANEL REMOVAL STEPS
Insert “T-Handle” Hex-key wrench into small hole near the top, side edge of panel.
Turn 3/4 turn Counter-Clockwise to release latch.
Repeat above steps for other small hole at opposite side of panel. Be ready to catch
panel.
Tilt panel away from the Bollard, then lift up to remove from lower pins. Use wrench to get tilt-out started if necessary,
by applying slight pressure down on wrench and pulling, simultaneously. (minimal force)
Place removed panel in safe location. Take care to avoid damaging finish or creating a hazard to pedestrian traffic.
PANEL INSTALLATION STEPS
Place panel on Hinge Points.
Tilt into place in Bollard.
Insert “T-Handle” Hex-key wrench into small hole near the top, side edge of panel.
Turn 3/4 turn Clockwise to latch.
Repeat for other small hole on opposite side of panel
BOLLARD INTERNAL ACCESS
SIDE PANEL REMOVAL
END PANEL REMOVAL
USE HEX TOOL
TO REMOVE
BOTTOM DOOR
REMOVE SCREW
FROM THIS
LOCATION TO
REMOVE END
END REMOVAL STEPS
After removing bottom access panel, remove screws shown in lower right image
Stand at end, grip both sides of end-panel and lift straight up, then pull toward you.
END INSTALLATION STEPS
Stand at end, grip both sides of end-panel, and align straight onto pedestal, approximately 1” above finish location.
Lower end-panel onto hook system
Install screws at locations shown in lower right image
Содержание DSI ES8300
