Datalogic AV500, Руководство по продукции

Страница: 305 / 324

MAINTENANCE TASKS
PRODUCT REFERENCE GUIDE
285
Tighten Mounting Hardware
1. Check all AV500, Deflection Mirrors, CBX connection boxes, and power supply
mounting hardware as applicable. Tighten as necessary. Do not over ‐ tighten. Be
sure not to disturb the equipment’s alignment as it relates to the product trans ‐
port.
2. Check the mounting hardware of the Photoelectric Sensor (if this option is being
used). Tighten as necessary. Do not over ‐ tighten.
3. Check the mounting hardware of the tachometer (if this option is being used).
Tighten as necessary. Do not over ‐ tighten.
Checking Camera System Connections
This is a safety check recommended for harsh environments where vibration may be a
problem.
(See “Electrical Installation” on page 41)
1. Check all wiring connections to the camera and illumination connector panels.
Tighten any loose connections as necessary. Do not over ‐ tighten.
2. Check all wiring connections to the CBX connection box. Tighten any loose connec ‐
tions as necessary. Do not over ‐ tighten.
3. Check all cabling/conduit for signs of wear/damage. Repair/replace any damaged
cable connections as necessary.
Verify Camera Operation
If after performing maintenance, the imaging system continues to perform below the
normal operations experienced with the system under normal daily conditions, contact
Datalogic through our website at www.datalogic.com.
Verify Photoelectric Sensor Operation
1. Block the Photoelectric Sensor emitter beam to confirm it is aligned properly with
the reflector.
2. Verify that the TRIGGER LED on camera lights when photoelectric sensor beam is
blocked.
3. If the photoelectric sensor’s LED does not change status, adjust the photoelectric
sensor so that it is properly aligned with the reflector.
4. If the TRIGGER LED on the barcode reader does not light when the photoelectric
sensor’s beam is blocked, check the cabling between the photoelectric sensor and
CBX connection box for damage.