Datalogic AV500, Руководство по продукции

Страница: 118 / 324

E-GENIUS
98
AV500 2D CAMERA
through the system not which camera it will be providing the focus to.
Far Distance
Enter the S85 Far Distance. The Far Distance is the greatest distance away from the AV500 that
a label will be found. In most cases this is the far side of the conveyor but there are some
application where the far side of the conveyor and the far working distance of the AV500 can
be different.
Far Distance Offset
Enter the S85 Far Distance Offset. This value is used when the S85 is unable to be set to the
correct distance due to some restriction. This value is added to the far Distance of the S85 and
compensates the focusing information.
Trigger Source to S85
Enter the distance from the trigger source to the light curtain.
Transmit Point Settings
Transmit Point Reference Edge
Select Leading Edge or Trailing Edge from the drop ‐ down list to reference the leading or trailing
edge of the package.
Distance to Transmit Point
Enter the distance from the location of the trigger source to the host transmit point.
Transmit Point Advance
Enter the distance. This is the distance upstream of the transmit point when the camera will
stop decoding the image data. This will help eliminate processing errors.
Transmit Early If Decode Complete
Click the check box to transmit when decode is completed.
Transmit Early if New Trigger
Click the check box to transmit when new trigger is received.
Green Spot Settings
Green Spot Mode
Select one of the following from the drop ‐ down list:
•Disabled
•
Good Read
‐ Immediate: this option will light the green LED at the time of the bar code
being decode. In an array only the AV500 that read the bar code will light
•
Good Read - Host Transmission:
this option will light the green LED when the package
reaches the transmit point. In the on ‐ line mode it will light when the trailing edge of the
package leaves the trigger photo sensor. In the Packtrack mode it will light when the defined
edge of the package, leading or trailing, arrives at the Distance To Transmit Point setting.
Green Spot On Time
Specify the amount of time is milliseconds that the Green Spot should remain on.
Redundant Controller Settings
Controller Mode: Camera_1
Select one of the following from the drop ‐ down list:
•
Auto-Detect:
this option is used when a CBX is used in the array. All AV500 units in the
array will check the status of the bit created by the IDNet jumper. The one that identifies the
connection will become the controller.
•
Primary Controller:
Select if the camera you are setting up is the Primary Controller.
•
Secondary Controller:
Select if the camera you are setting up is the Secondary Controller.
Tunnel Software Update
Allow automatic software updates
Select the check box to enable all cameras in the tunnel to automatically update when
software is loaded to one of the cameras.