Datalogic AV500, Руководство по продукции

Страница: 283 / 324

SETTING UP THE DM3610 DIMENSIONER
PRODUCT REFERENCE GUIDE
263
Preparation
Before beginning the DM3610 focusing process, a few preliminary settings are required.
1. In the DM3610 e ‐ Genius under Modify Settings , navigate to Serial | Main or Aux
depending on the port wired to the AV500 (typically Main, consult your applica ‐
tion interconnect diagrams for details). The Serial | Main window opens.
2. Make sure the selected Baud Rate matches that of the AV500 (AV500 uses the
main port, RS485 (RS422), at 115200).
3. Under Message Format , select Camera Focus from the Focus messages for Data-
logic cameras drop ‐ down list.
4. Select the Model of camera for which you are focusing.
5. Enter the Focus Transmit Point . This is the distance the DM3610 waits until after
the AV500 scan line has read, to transmit the message. This value correlates to a
value in the AV500 settings. Default is 8 inches.
For single Dimensioner applications, the DM3610 must be running software version 1.8.11
or greater. For multi-head applications, the DM3610’s must be running 1.8.1 and the
DC3000 must be version 1.3.60 or greater.
The Dimensioner scan line must be installed at least 500 mm [20 in] upstream from the
nearest camera scan line.
The examples used in this guide use Imperial units i.e. inches. If the system is configured
for metric, the unit of measure will be in mm.
Remember to reset these parameters to the application specifications after the calibration is
complete.
When working with a multi-head Dimensioning system, the focus setup steps apply to the
unit designated as the “Tach Master” by the DC3000.