P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PAG E 1 8
NOTE 4:
Introduce only pre-ground coffee for espresso coffee machines into the funnel. Never fill with
coffee beans, freeze dried coffee or other substance that could damage the appliance.
NOTE 5:
If more than one measure of pre-ground coffee is used and the funnel clogs, push the coffee
down with a knife then remove and clean the infuser and machine as described in the
“Cleaning the infuser chapter”.
TIPS FOR A HOTTER COFFEE
• When you turn the appliance on, if you want to make a short coffee (less than 60ml),
it is advisable to pre-heat your cup with hot water.
• If more than 2-3 minutes have passed since the last coffee made, before requesting
another coffee, you must preheat the infuser. Deliver the water into the underlying drip tray
or alternatively use this water to fill (and then empty) the cup to be used for the coffee,
so as to preheat it.
• Unless preheated, do not use excessively thick cups as they will absorb too much heat.
• Preheat the cups by rinsing them or filling them with hot water for 1-2 minutes before use.
NOTE
When the appliance displays “fill water”, fill the tank with water or the appliance will not deliver
coffee. (It is normal for there to be a little water left in the tank when the message is displayed).
• After approximately 15 coffees, the appliance will display “EMPTY GROUNDS“, indicating
that the ground container is full and must be emptied and cleaned.
• Until the ground container has been cleaned. The appliance continues to display the
message and coffee cannot be made.
• To clean, extract the drip tray (A9), empty and clean.
• When cleaning, always extract the drip tray completely to avoid it falling when the ground
container is removed.
• Empty the ground container and clean thoroughly to remove all residues left on the bottom.
NOTE
When the appliance displays “empty tray“, this is indicating that drip tray is full of waste water.
To clean the drip tray must be extracted and the water needs to be emptied from it, remember to
give the drip tray a quick clean before placing back into its original position. Once the tray is re-
inserted the machine will go back into its “ready” state.
