P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PAG E 1 4
SETTING THE WATER HARDNESS
The harder the water is, the more frequently your DANIELA coffee machine will require descaling.
Purchase a special strip then deep fully in the water for a few seconds, remove and wait about 30
seconds, until it changes colour and forms red squares, according the colour gauge you can
Read out the water hardness level.
You can set the water hardness level according to the strip value.
SETTING THE TIME
To set the time, proceed as follows:
1. When in “ready” state, Press the B8 button, select the “display”.
2. Press the B8 button to enter next select----CC/OZ then select time.
3. Press
“+” key or “+” key let LCD display “time”, press B8 and LCD may display “--/--” hours
number flash.
4. Next press “+” key or “+” key until the unit displays the hour you require.
5. Press B8 that once you have the hour you require.
6. Next the LCD will display “**/-- “--- and the minute side of the time will flash.
7. Press
“+” key or “+” key until it displays the minutes you require.
8. Press
“enter” key to complete setting the minutes.
ADJUSTING YOUR PRE-SET COFFEE (ml)
If you wish to change the pre-set ml for your coffee---- CC/OZ.
1. When in “ready” state, Press the B8 button, select the “display”.
2. Press the B8 button to enter next select ----CC/OZ then select CC.
3. Follow the prompts until you have selected the amount of ml/cc you require.
4. Press enter to save your selection.
USING FOR FIRST TIME
All machines are tested in the factory therefore its completely normal for there to be traces
of coffee in the mill.
• You should set water hardness as soon as possible following the instructions in the
“Setting water hardness” chapter.
• Connect the appliance to the mains electricity supply and turn on the main switch (A5).
• Press on/off button to turn on this machine.
• Fill the water tank to the “max” line.
• Fill the beans compartment with good quality beans. Avoid flavoured, caramelized beans,
as they may damage your grinder.
