P
I
02 9604 1226 E
I
|
danielaappliances.com.au
PAG E 1 6
NOTE 3:
Tips for a hotter coffee:
• When you turn the appliance on, if you want to make a short coffee (less than 60cc/ml),
rinse the cups with hot water to preheat the cups.
• If more than 2-3 minutes have passed since the last coffee made, before requesting another
coffee, you must preheat the infuser.
• Deliver the water into the underlying drip tray or alternatively use this water to fill
(and then empty) the cup to be used for the coffee, so as to preheat it.
• Unless preheated, do not use excessively thick cups as they will absorb too much heat.
• Preheat the cups by rinsing them with hot water.
NOTE 4:
When the appliance displays “fill water”, fill the tank with water or the appliance will not deliver
coffee. (It is normal for there to be a little water left in the tank when the message is displayed).
NOTE 5:
After about 15 times coffees. The appliance displays ‘EMPTY GROUND “, indicating that the
ground container is full and must be emptied and cleaned. Until the ground container has been
cleaned. The appliance continues to display the message and coffee cannot be made.
• To clean, extract the drip tray (A9), empty and clean.
• When cleaning, always extract the drip tray completely to avoid it falling when the ground
container is removed.
• Empty the ground container and clean thoroughly to remove all residues left on the bottom.
NOTE 6:
When the appliance displays “empty tray”, indicating that drip tray is full of waste water, this
means you must extract the drip tray and pull all water and clean it and come back to original
position then this machine goes back to “ready” state.
IMPORTANT!
When removing the drip tray, the ground container must be emptied, even if it is not completely
full. If this is not done, when you make the next coffee, the ground container may fill up more than
expected and clog the machine.
NOTE 7:
Never extract the water tank while the machine is delivering coffee.
If it is removed, it will not be possible to make the coffee and the appliance will display
“fill water”. Put the water tank in original position, the interrupt program will go on to finish.
