SERVICE
13
MAGNET POWER SUPPLY SYSTEM 8500
AUXILIARY OUTPUT-2 ON PULSE TIME SETUP.
From SW version SCS108
As an option, can the polarity switch control line can be used as an auxiliary output line 2 exact in
the same way as for the auxiliary -1 line(see previous page).
To disable the polarity sequence and to use the output port as an auxiliary output line, a new software
configuration must be given. This can only be done by authorised Danfysik service personnel.
If enabled the Auxiliary-2 output line can be programmed to produce a pulse or a static level output,
software commend N2, F2. Below are the settings for this Auxiliary line
Parameters
Default setting after “COLD BOOT”
Disabled auxiliary-2 option (enabled polarity change over sequence).
DANFYSIK A/S - DK 2630 TAASTRUP - DENMARK.
DOC NO P80303Sk