SERVICE
10
MAGNET POWER SUPPLY SYSTEM 8500
AUXILIARY SETUP 1.
Special options can be initiated with the auxiliary switch set up 1.
Setting of bit 16 and 17 is intended for Offset DAC use. That is a 16 bit setting between 88 and 96%
(Bit16=0 & BIT 17=1) or between 92% and 100% output current (Bit16=1 & BIT 17=1).
For linear DAC settings, please set bit 16 & 17 to transparent mode.
Using the “WA” command a leading zeroes or trailing zeroes input format can be chosen.
- For leading zeroes: “WA 123" equals “WA 000123"
- For trailing zeroes: “WA 123" equals “WA 123000"
Parameters:
Default setting after “COLD BOOT”
DAC 16 & 17:
Transparent
Interlock clear:
OFF & CLEAR resets interlocks
“WA” Zeroes:
WA command uses trailing zeroes.
UNI/BI-Polar DAC:
UNIPOLAR (From SW version SCS108)
If a CAMAC Control Module is not inserted at slot P3 (Pin P3.A32 pulled low), the DAC port may
be configured as an output by setting lever 6 to ON. This enables either the DAC bits to be analysed
or to be connected to another power supply in a parallel tracking mode (the second supply must be
configured for CAMAC control). Default setting is disabled, that is High impedance.
DANFYSIK A/S - DK 2630 TAASTRUP - DENMARK.
DOC NO P80303Sk