Danfoss VLT HVAC FC 100, Руководство по обслуживанию, Страница: 25 / 220

Display lines:
a. Status line: Status messages dis-
playing icons and graphics.
b.
Line 1-2:
Operator data lines dis-
playing data and variables defined or
chosen by the user. By pressing the
[Status] key, up to one extra line can
be added.
c. Status line: Status messages dis-
playing text.
The display is divided into three sections:
The
Top section
(a) shows the status when in status mode or up to two variables when not in
status mode and in the case of an alarm/warning.
The number of the Active Set-up (selected as the Active Set-up in par. 0-10
Active Set-up
) is
shown. When programming in another set-up than the Active Set-up, the number of the set-up
being programmed appears to the right in brackets.
The Middle section (b) shows up to 5 variables with related unit, regardless of status. In the
case of an alarm/warning, the warning is shown instead of the variables.
It is possible to toggle between three status readout displays by pressing the [Status] key.
Operating variables with different formatting are shown in each status screen - see below.
Several values or measurements can be linked to each of the displayed operating variables. The
values/measurements to be displayed can be defined via par. 0-20, 0-21, 0-22, 0-23, and 0-24,
which can be accessed via [QUICK MENU]
Q3 Function Set-ups, Q3-1 General Settings, Q3-13
Display Settings
.
Each value/measurement readout parameter selected in par. 0-20
Display Line 1.1 Small
to
par. 0-24
Display Line 3 Large
has its own scale and number of digits after a possible decimal
point. Larger numeric values are displayed with few digits after the decimal point.
Ex.: Current readout
5.25 A; 15.2 A 105 A.
2 Operator Interface and Adjustable Frequen-
cy Drive Control
High Power Service Manual for VLT
®
FC Series
Adjustable Frequency Drives
2-2
MG.90.L1.22 - VLT ® is a registered Danfoss trademark
2