This procedure initialises all except:
•
15-00 Operating Hours
•
15-03 Power Up's
•
15-04 Over Temp's
•
15-05 Over Volt's
5.2.7 Data Transfer from LCP to Frequency
Converter
NOTE
Stop the motor compressor before performing this
operation.
1.
Go to
0-50 LCP Copy
.
2.
Press [OK].
3.
Select
[2] All from LCP
.
4.
Press [OK] again.
The parameter settings stored in the LCP are now
transferred to the frequency converter indicated by the
progress bar. When 100% is reached, press [OK].
5.2.8 Parameter Selection
In the
Main menu mode
, the parameters are divided into
groups. Use the navigation keys for selecting a parameter
group.
The following parameter groups are accessible:
•
0-** Operation/Display
•
1-** Load/Motor
•
2-** Brakes
•
3-** Reference/Ramps
•
4-** Limits/Warnings
•
5-** Digital In/Out
•
6-** Analog In/Out
•
7-** Controls
•
8-** Comm. and Options
•
13-** Smart Logic
•
14-** Special Functions
•
15-** Drive Information
•
16-** Data Readouts
•
25-** Cascade Controller
•
28-** Compressor Functions
After selecting a parameter group, choose a parameter
with the navigation keys. The middle section on the
display shows the parameter number and name as well as
the selected parameter value.
Illustration 5.5
5.2.9 Changing Data
The procedure for changing data is the same in both the
Quick menu and the Main menu mode.
Press [OK] to change the selected parameter. The
procedure for changing data depends on whether the
selected parameter represents a numerical data value or a
text value.
5.2.10 Changing a Text Value
If the selected parameter is a text value, change the text
value by pressing the [
▲
]/[
▼
] navigation keys. [
▲
] increases
the value and [
▼
] decreases the value. Place the cursor on
the value and press [OK] to save.
5.2.11 Changing a Group of Numeric Data
Values
If the chosen parameter represents a numeric data value,
change it by pressing the navigation keys. Press [
◀
]/[
▶
] to
move the cursor horizontally. Press [
▲
]/[
▼
] to change the
data value. [
▲
] enlarges the data value, and [
▼
] reduces
the data value. Place the cursor on the value and press
[OK] to save.
How to Program
Operating Instructions VLT
®
CDS302 and CDS303
MG34M302 - VLT
®
is a registered Danfoss trademark/Commercial Compressor
43
5
5
