Service guide
|
Disassembling and Assembling, iSave 50-70
© Danfoss | DCS (im) | 2016.10
180R9387 | 521B1430 | DKCFN.PI.013.1H.02 | 21
5. Mount the 8 vanes. (Steel inside vanes
should be visible clock wise to the shaft
center.)
8. Mount 2 x eyebolts in 2 of the M12 holes
in the motor flange and carefully lower the
motor flange on the stator housing and
the 2 pins.
(Be carefully not to scratch the bearings).
6. Apply a thin layer of lubrication (not water)
on the O-ring for the motor flange.
7. Make sure to mount the O-ring correctly
in the groove so that it does not twist.
Remove excess lubrication from the motor
flange. This is to keep the O-ring in place
when turning the flange upside down.
9. Lubricate all the screws but first mount
only 4 screws that are evenly placed
around the motor flange.
10. By hand only carefully cross tighten the
4 screws (max. 10 Nm) to ensure the motor
flanges are tightened evenly onto the
stator housing.