Service guide
|
Disassembling and Assembling, iSave 50-70
© Danfoss | DCS (im) | 2016.10
18 | 180R9387 | 521B1430 | DKCFN.PI.013.1H.02
2. Mount 2 lifting eyes across from each
other in the stator housing to equal
weight. Carefully lower the stator housing
into the 6 stud bolt holes and small pin.
Remove the 2 lifting eyes and the lifting
strap.
1. Lubricate the stud bolt. Tilt the stator
housing and the intermediate flange with
the port plate mounted horizontally.
Mount the stud bolts in the intermediate
flange and tighten to the torque according
to exploded view.
7. Continue assembling the
pressure exchanger
5. Lubricate the intermediate flange and port
plate (feed) with clean filtered water and
mount the port plate (feed) over the clips
and pins.
Make sure that the clips are below the
port flange surface.
4. Lubricate small pin and the small pin hole
and mount 2 new clips, 2 new pins and a
new O-ring on the intermediate flange.