![background image](http://html1.mh-extra.com/html/danfoss/isave-40/isave-40_operation-manual_3540938075.webp)
Operation guide | iSave 40
75
180R9239 | AQ299555093252en-001601 | iSave 40 | 09.2022
17. Install the 8 pins inside the rotor.
Two pins per hole.
18. Spray the inside of the housing with
clean filtered water before installing
the rotor.
20. Install the vanes. Use a screwdriver to
push the pins in place to allow room
for the vanes. Steel inside vanes
should be visible clock wise to
the shaft center.
19. Carefully lower the rotor assembly into
the housing. Taking care not to damege
the side plate or the bearing. Spray the
rotor with clean filtered water before
installing the vanes.
21. Install the rotor stop in the portflange.
Use a small amount of grease on the
bottom of the rotor stop to keep the
rotor stop from falling out when the
flange is turned around.
22. The narrow part of the motor stop must
point downwards.
Содержание iSave 40
Страница 34: ...Operation guide iSave 40 34 180R9239 AQ299555093252en 001601 iSave 40 09 2022 iSave 40 Code no 180F7011...
Страница 53: ...Operating guide Energy recovery device iSave 40 Appendices hpp danfoss com...
Страница 96: ...M a n u a l Electric Motors Motor Manual hoyermotors com...
Страница 100: ...101 180R9379 AQ188686503004en 000801 PAH 2 12 5 07 2022...