Danfoss D9h, Руководство по эксплуатации

Страница: 160 / 206

Symptom Possible cause Test Solution
Mains current
imbalance
greater than 3% Problem with mains power
(see
Alarm 4, Mains phase loss
description).
Rotate input power leads into the
AC drive 1 position: A to B, B to C, C
to A. If imbalanced leg follows the wire, it is
a power problem. Check the mains
supply.
Problem with the AC drive. Rotate input power leads into the
AC drive 1 position: A to B, B to C, C
to A. If the imbalanced leg stays on same in-
put terminal, it is a problem with the
AC drive. Contact the supplier.
Motor current
imbalance
greater than 3% Problem with motor or motor
wiring. Rotate output motor cables 1 posi-
tion: U to V, V to W, W to U. If the imbalanced leg follows the wire,
the problem is in the motor or motor
wiring. Check motor and motor wiring.
Problem with AC drive. Rotate output motor cables 1 posi-
tion: U to V, V to W, W to U. If the imbalanced leg stays on same
output terminal, it is a problem with
the unit. Contact the supplier.
AC drive accel-
eration prob-
lems Motor data are entered incor-
rectly. If warnings or alarms occur, refer to
the
Warnings and Alarms section.
Check that motor data are entered
correctly.
Increase the ramp-up time in parame-
ter 3-41 Ramp 1 Ramp Up Time . In-
crease current limit in parameter 4-18
Current Limit . Increase torque limit in
parameter 4-16 Torque Limit Motor
Mode
.
AC drive decel-
eration prob-
lems Motor data are entered incor-
rectly. If warnings or alarms occur, refer to
the
Warnings and Alarms section.
Check that motor data are entered
correctly.
Increase the ramp-down time in pa-
rameter 3-42 Ramp 1 Ramp Down Time .
Enable overvoltage control in parame-
ter 2-17 Over-voltage Control .
AQ262139143212en-000301 / 130R0879 160 | Danfoss A/S © 2021.10
Maintenance, Diagnostics, and
Troubleshooting
VLT® AutomationDrive FC 302
Operating Guide