Daikin REYQ96MTJU, Инструкция по проектированию, установке и испытаниям, Страница: 224 / 236

Precautions for New Refrigerant (R410A) Si39-406
218 Precautions for New Refrigerant (R410)
1.3 Service Tools
R410A is used under higher working pressure, compared to previous refrigerants (R22,R407C).
Furthermore, the refrigerating machine oil has been changed from Suniso oil to Ether oil, and if oil
mixing is occurred, sludge results in the refrigerants and causes other problems. Therefore, gauge
manifolds and charge hoses that are used with a previous refrigerant (R22,R407C) can not be used
for products that use new refrigerants.
Be sure to use dedicated tools and devices.
„
Tool compatibility
As for the charge mouthpiece and packing, 1/2UNF20 is necessary for mouthpiece size of
charge hose.
Tool
Compatibility
Reasons for change HFC HCFC
R410A R407C R22
Gauge manifold
Charge hose
✕
2
Do not use the same tools for R22 and
R410A.
2
Thread specification differs for R410A
and R407C.
Charging cylinder
✕
{
2
Weighting instrument used for HFCs.
Gas detector
{
✕
2
The same tool can be used for HFCs.
Vacuum pump
(pump with reverse flow
preventive function)
{
2
To use existing pump for HFCs, vacuum
pump adaptor must be installed.
Weighting instrument
{
Charge mouthpiece
✕
2
Seal material is different between R22
and HFCs.
2
Thread specification is different between
R410A and others.
Flaring tool (Clutch type)
{
2
For R410A, flare gauge is necessary.
Torque wrench
{
2
Torque-up for 1/2 and 5/8
Pipe cutter
{
Pipe expander
{
Pipe bender
{
Pipe assembling oil
✕
2
Due to refrigerating machine oil change.
(No Suniso oil can be used.)
Refrigerant recovery
device
Check your recovery device.
Refrigerant piping See the chart below.
2
Only
φ
19.1 is changed to 1/2H material
while the previous material is "O".