Si39-406
Refrigerant Piping
Installation Manual REYQ96MTJU
155
FLARE SHAPE and FLARENUT TIGHTENING TORQUE
<Precautions when connecting pipes>
See the following table for flare part machining dimensions.
When connecting the flare nuts, apply refrigerant oil to the inside and outside of the flares and
turn them three or four times at first. (Use ester oil or ether oil.)
See the following table for tightening torque.
(Applying too much torque may cause the flares to crack.)
After all the piping has been connected, use nitrogen to perform a gas leak check.
Not recommendable but in case of emergency
You must use a torque wrench but if you are obliged to install the unit without a torque wrench, you
may follow the installation method mentioned below.
After the work is finished, make sure to check that there is no gas leak.
When you keep on tightening the flare nut with a spanner, there is a point where the tightening
torque suddenly increases. From that position, further tighten the flare nut the angle shown below:
(in.)
Disposal
requirements
Dismantling of the unit, treatment of the refrigerant, oil and eventual other parts, should be done in
accordance with the relevant local and national regulations.
pipe size (in.)
tightening
torque (ft.-lbf)
A (in.)
flare shape (in.)
φ
3/8”
24.1 - 29.4
0.504 - 0.520
φ
1/2”
36.5 - 44.5
0.638 - 0.654
φ
5/8”
45.6 - 55.6
0.760 - 0.776
Pipe size
Further tightening angle
Recommended arm length of tool
φ
3/8"
60 to 90 degrees
Approx. 7 7/8
φ
1/2"
30 to 60 degrees
Approx. 9 13/16
φ
5/8"
30 to 60 degrees
Approx. 11 13/16
φ
3/4"
20 to 35 degrees
Approx. 17 3/4
R=0.016-0.031
45 ±2
90 ±2
A
Содержание REYQ96MTJU
