xStack Gigabit Layer 3 Switch Command Line Interface Manual
1
I
NTRODUCTION
The Switch can be managed through the Switch’s serial port, Telnet, or the Web-based management agent. The Command Line
Interface (CLI) can be used to configure and manage the Switch via the serial port or Telnet interfaces.
This manual provides a reference for all of the commands contained in the CLI for members of the xStack family, including the
DGS-3324SRi, DGS-3324SR, DXS-3326GSR and the DXS-3350SR. Examples present in this manual may refer to any member
of the xStack family and may show different port counts, but are universal to this series of switches, unless otherwise stated.
Configuration and management of the Switch via the Web-based management agent is discussed in the User’s Guide.
Accessing the Switch via the Serial Port
The Switch’s serial port’s default settings are as follows:
•
115200 baud
•
no parity
•
8 data bits
•
1 stop bit
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port configured as
above is then connected to the Switch’s serial port via an RS-232 DB-9 cable.
With the serial port properly connected to a management computer, the following screen should be visible. If this screen does
not appear, try pressing Ctrl+r to refresh the console screen.
Figure 1-1. Initial CLI screen
There is no initial username or password. Just press the
Enter
key twice to display the CLI input cursor
−
DGS-3324SRi:4#
.
This is the command line where all commands are input.
1
