xStack Gigabit Layer 3 Switch Command Line Interface Manual
config fdb destination_hit ports
Restrictions Only
administrator-level users can issue this command.
Example usage:
To configure ports 1 to 5 as destination hit ports:
DGS-3324SRi:4#config fdb destination_hit ports 1:1-1:5 enable
Command: config fdb destination_hit ports 1:1-1:5 enable
Success.
DGS-3324SRi:4#
show fdb destination_hit ports
Purpose
To view the destination hit port status of ports on the Switch.
Syntax
show fdb destination_hit ports {<portlist>}
Description
This command will allow users to view the destination hit port status
of ports listed in the portlist.
Parameters
{<portlist>}
-
Specify a port or ports to be displayed. The port list is
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the
port list range are separated by a dash. For example, 1:3 specifies
switch number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-
2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4
−
in numerical order.
Entering this command without a specified
<portlist>
will allow the
user to view the destination hit port status of all ports on the Switch.
Restrictions None.
Example usage:
To view the destination hit port status:
99
