xStack Gigabit Layer 3 Switch Command Line Interface Manual
DGS-3324SRi:4# config traffic_segmentation 1
:
1-1
:
10 forward_list 1
:
11-1
:
15
Command: config traffic_segmentation 1
:
1-1
:
10 forward_list 1
:
11-1
:
15
Success.
DGS-3324SRi:4#
show traffic_segmentation
Purpose
Used to display the current traffic segmentation configuration on the
Switch.
Syntax
show traffic_segmentation <portlist>
Description
The
show traffic_segmentation
command is used to display the
current traffic segmentation configuration on the Switch.
Parameters
<
portlist>
−
Specifies a range of ports for which the current traffic
segmentation configuration on the Switch will be displayed. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4
−
in numerical order.
Restrictions
The port lists for segmentation and the forward list must be on the
same switch.
Example usage:
To display the current traffic segmentation configuration on the Switch.
DGS-3324SRi:4#show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
---- ----------------------------
1:1 1:11-1:15,2:1-2:24
1:2 1:11-1:15,2:1-2:24
1:3 1:11-1:15,2:1-2:24
1:4 1:11-1:15,2:1-2:24
1:5 1:11-1:15,2:1-2:24
1:6 1:11-1:15,2:1-2:24
1:7 1:11-1:15,2:1-2:24
1:8 1:11-1:15,2:1-2:24
1:9 1:11-1:15,2:1-2:24
1:10 1:11-1:15,2:1-2:24
1:11 1:1-1:24,2:1-2:24
1:12 1:1-1:24,2:1-2:24
1:13 1:1-1:24,2:1-2:24
1:14 1:1-1:24,2:1-2:24
1:15 1:1-1:24,2:1-2:24
237
