D-Link DGS-3212SR, Справочное руководство по интерфейсу командной строки

Страница: 85 / 269

DGS-3212SR Layer 3 Gigabit Switch
config syslog host
16 local use 0 (local0)
17 local use 1 (local1)
18 local use 2 (local2)
19 local use 3 (local3)
20 local use 4 (local4)
21 local use 5 (local5)
22 local use 6 (local6)
23 local use 7 (local7)
local0
−
Specifies that local use 0 messages will be sent to the
remote host. This corresponds to number 16 from the list above.
local1
−
Specifies that local use 1 messages will be sent to the
remote host. This corresponds to number 17 from the list above.
local2
−
Specifies that local use 2 messages will be sent to the
remote host. This corresponds to number 18 from the list above.
local3
−
Specifies that local use 3 messages will be sent to the
remote host. This corresponds to number 19 from the list above.
local4
−
Specifies that local use 4 messages will be sent to the
remote host. This corresponds to number 20 from the list above.
local5
−
Specifies that local use 5 messages will be sent to the
remote host. This corresponds to number 21 from the list above.
local6
−
Specifies that local use 6 messages will be sent to the
remote host. This corresponds to number 22 from the list above.
local7
−
Specifies that local use 7 messages will be sent to the
remote host. This corresponds to number 23 from the list above.
udp_port <int>
−
Specifies the UDP port number that the syslog
protocol will use to send messages to the remote host.
ipaddress <ipaddr>
−
Specifies the IP address of the remote host
where syslog messages will be sent.
state [enable | disable]
−
Allows the sending of syslog messages
to the remote host, specified above, to be enabled and disabled.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure a syslog host:
73