D-Link DGS-3212SR, Справочное руководство по интерфейсу командной строки

Страница: 128 / 269

DGS-3212SR Layer 3 Gigabit Switch
config mirror delete
according to ports entered using the <portlist>.
<portlist>
−
This specifies a range of ports that will be
mirrored. That is, the range of ports in which all traffic will be
copied and sent to the Target port. The port list is specified
by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The
beginning and end of the port list range are separated by a
dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4
−
in
numerical order.
rx
−
Allows the mirroring of only packets received by (flowing into)
the port or ports in the port list.
tx
−
Allows the mirroring of only packets sent to (flowing out of) the
port or ports in the port list.
both
−
Mirrors all the packets received or sent by the port or ports
in the port list.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete the mirroring ports:
DGS-3212SR:4#config mirror port 1:5 delete source port 1:1-1:5 both
Command: config mirror 1:5 delete source 1:1-1:5 both
Success.
DGS-3212SR:4#
enable mirror
Purpose Used to enable a previously entered port mirroring configuration.
Syntax enable mirror
Description This command, combined with the disable mirror command
below, allows you to enter a port mirroring configuration into the
switch, and then turn the port mirroring on and off without having
to modify the port mirroring configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
116