D-Link DGS-3212SR, Справочное руководство по интерфейсу командной строки

Страница: 248 / 269

DGS-3212SR Layer 3 Gigabit Switch
29
T
IME AND
SNTP C
OMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time <date ddmmmyyyy > <time hh:mm:ss>
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
config dst
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day
sun-sat>| s_mth <start_mth 1-12> | s_time <start_time hh:mm> |
e_week <end_week 1-4,last> | e_day <end_day sun-sat> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]}]
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose Used to setup SNTP service.
Syntax
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-
interval <int 30-99999>}
Description Use this command to configure SNTP service from an SNTP
server. SNTP must be enabled for this command to function (See
enable sntp).
Parameters
secondary
−
This is the secondary server the SNTP information
will be taken from in the event the primary server is unavailable.
poll-interval <int 30-99999>
−
This is the interval between
requests for updated SNTP information. The polling interval
ranges from 30 to 99,999 seconds.
primary
−
This is the primary server the SNTP information will be
taken from.
<ipaddr>
−
The IP address for the secondary server.
<ipaddr>
−
The IP address of the primary server.
236