D-Link DGS-3212SR, Справочное руководство по интерфейсу командной строки

Страница: 138 / 269

DGS-3212SR Layer 3 Gigabit Switch
16
L
INK
A
GGREGATION
C
OMMANDS
The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create
link_aggregation group_id <value 1-6> {type [lacp | static]}
delete
link_aggregation group_id <value 1-6>
config
link_aggregation group_id <value 1-6> {master_port <port> | ports <portlist> state
[enable | disable]}
config
link_aggregation
algorithm [mac_source | mac_destination | mac_source_dest | ip_source |
ip_destination | ip_source_dest]
show link_aggregation {group_id <value 1-6> | algorithm}
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
Each command is listed, in detail, in the following sections.
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
create link_aggregation
Purpose Used to create a link aggregation group on the switch.
Syntax create link_aggregation group_id <value 1-6> {type [lacp |
static]}
Description This command will create a link aggregation group with a unique
identifier.
Parameters
<value 1-6>
−
Specifies the group ID. The switch allows up to 6
link aggregation groups to be configured. The group number
identifies each of the groups.
type – Specify the type of link aggregation used for the group. If
the type is not specified the default type is static.
lacp – This designates the port group as LACP compliant.
LACP allows dynamic adjustment to the aggregated port
group. LACP compliant ports may be further configured (see
config lacp_ports). LACP compliant must be connected to
LACP compliant devices.
126