DGS-3024 Layer 2 Switch CLI Reference Manual
delete link_aggregation group_id
aggregation groups to be configured. The group number identifies each of
the groups.
Restrictions Only
administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DGS-3024:4#delete link_aggregation group_id 1
Command: delete link_aggregation group_id 1
Success.
DGS-3024:4#
config link_aggregation
Purpose
Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-4> {master_port <port> |
ports <portlist> | state [enable | disable]}
Description
This command allows you to configure a link aggregation group that was
created with the create link_aggregation command above.
Parameters
<value 1-4>
−
Specifies the group ID. The Switch allows up to 4 link
aggregation groups to be configured. The group number identifies each of
the groups.
master port <port>
−
Master port ID. Specifies which port (by port number)
of the link aggregation group will be the master port. All of the ports in a link
aggregation group will share the port configuration with the master port.
ports <portlist>
−
Specifies a port or range of ports that will belong to the
link aggregation group. Ports may be listed in only one port aggregation
group, that is, link aggregation groups may not overlap.
state [enable | disable]
−
Allows the user to enable or disable the specified
link aggregation group.
Restrictions
Only administrator-level users can issue this command. Link aggregation
groups may not overlap and must be contained on a single switch.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 of module 1 with group members ports 5-7 plus port
9:
DGS-3024:4#config link_aggregation group_id 1 master_port 5 ports 5-7,9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7,9
Success.
DGS-3024:4#
96
