Cyclades AlterPath ACS, Справочник по командам

Страница: 67 / 420

AlterPath ACS Command Reference Guide
51
Device Access
Step 2 - Add a slave box.
cli>config virtualports addslave 172.22.65.3
Step 3 - Configuring the slave box.
All parameters that have to be configured will be listed, commented and given
the correct value for this example.
•
numports: This sets the total number of ports of the slave box. The value for this
example is
32 .
•
firstlocalportnum: This parameter will act as the numbering continuation in the
slave box. As the master unit is a 4 port box, the first port of the slave unit will be
the first local port number. The value for this example is
5 .
•
localip: To set the IP address of the slave box. The value for the example is
172.22.65.3 .
•
firstlocaltcpport: Such as the firstlocalportnum parameter, but setting the tcp port.
The value for the example is 7005 .
•
remoteip: The IP address of the master box. The value for this example is:
172.22.65.2 .
•
firstremotetcpport: Where tcp port numbering starts in the master box. The value
for this example is: 7001.
•
protocol: Protocol used to access the ports. Valid values are: telnet or SSH .
Step 4 - Activate the configuration.
cli>config runconfig
Step 5 - Save the configuration.
cli>config savetoflash
Step 6 - Testing the configuration and additional options.
Telnet to port 10 of the slave box. Supposing you are in the same network as the
master ACS, run the command:
# telnet 172.22.65.2 7014
You can also edit or delete any previously configured virtual port:
cli>config virtualports editslave <n.n.n.n>
cli>config virtualports deleteslave <n.n.n.n>
Where n.n.n.n is the IP address of the configured virtual port.
Step 7 - Exiting the CLI mode.
To exit the CLI mode and return to ACS’s shell, type the following command:
cli> quit