Cyclades AlterPath ACS, Справочник по командам

Страница: 381 / 420

Troubleshooting
| 365
MAC address assigned to Ethernet [00:60:2E:01:6B:61] :
Step 11 - When the “Fast Ethernet” prompt appears, press <Enter>.
Fast Ethernet ((A)uto Neg, 100 (B)tH, 100 Bt(F), 10 B(t)F, 10 Bt(H)) [A] :
ACS should begin to boot off the network and the new image will be downloaded and
begin running in RAM. At this point, follow the upgrade process in section B.1 above to
save the new zImage file into flash again.
NOTE:
Possible causes for the loss of flash memory may include: downloaded wrong zImage
file, downloaded as ASCII instead of binary; problems with flash memory.
If the ACS booted properly, the interfaces can be verified using ifconfig and ping. If ping
does not work, check the routing table using the command route. Of course, all this
should be tried after checking that the cables are connected correctly.
The file /etc/config_files contains a list of files that are affected by saveconf and
restoreconf commands. At the command prompt issue the command cat /etc/config_files
to see the list of files that are available in the flash and are loaded into the RAMDisk at
the boot time.
IMPORTANT!
If any of the files listed in /etc/config_files is modified, the ACS administrator
must execute the command saveconf before rebooting the ACS or the changes will be lost. If
a file is created (or a filename altered), its name must be added to this file before executing
saveconf and rebooting.
IMPORTANT!
Cyclades Technical Support is always ready to help with any configuration
problems. Before calling, execute the command
# cat /proc/version
and note the Linux version and ACS version written to the screen. This will speed the
resolution of most problems.
Hardware Test
A hardware test called tstest is included with the ACS firmware. It is a menu-driven
program, run by typing tstest at the command prompt. The various options are described
below. Note that the ACS should not be tested while in use as the test will inactivate all
ports. You should inactivate all processes that may use the serial ports:
inetd , sshd ,
cy_ras , and cy_buffering . Following are the hardware test steps: