Cyclades AlterPath ACS, Справочник по командам

Страница: 321 / 420

AlterPath ACS Command Reference Guide
305
Profile Configuration
all.syslog_buffering When non zero, the contents of the data buffer are sent
to the syslog-ng every time a quantity of data equal to
this parameter is collected. The syslog level for data
buffering is hard coded to level 5 (notice) and facility
local[0+conf.DB_facility]. The file
/etc/syslog-
ng/syslog-ng.conf should be set accordingly for the
syslog-ng to take some action. (See Section 2.2,
“Data Buffering,” on page 29 to use it with Syslog
Buffering Feature.)
0
all.syslog_sess Syslog_buffering must be activated for the following
to work. When 0, syslog messages are always
generated whether or not there is a session to the port
sending data to the unit. When 1, syslog messages are
NOT generated when there IS a session to the port
sending data to the unit, but resumes generation of
syslog messages when there IS NOT a session to the
port. 0
all.dont_show_DBmenu When zero, a menu with data buffering options is
shown when a non empty data buffering file is found.
•
When 1, the data buffering menu is not shown.
When 2, the data buffering menu is not shown but
the data buffering file is shown if not empty.
•
When 3, the data buffering menu is shown, but
without the erase and show and erase options.
Note: This parameter is inactive by default. To
activate, uncomment the parameter and set the desired
value.
0
all.alarm When non zero, all data received from the port are
captured and sent to syslog-ng with level INFO and
local[0+conf.DB_facility]facility. The
syslog-ng.conf
file should be set accordingly, for the syslog-ng to take
some action (please see Section 5.4, “Syslog-ng,”
on page 161 for the syslog-ng configuration file).
0
Parameter Description Factory Configuration
Table 8.2: CAS specific parameters for the pslave.conf