Cyclades AlterPath ACS, Справочник по командам

Страница: 66 / 420

50
Device Access
Example of starting CAS session commands
The alias, socket_port, or tty must be provided to select which serial port is to be
connected to in the Slave box 1.
# ssh -l <username>:<slave-1-port[1-32]> -p 7000 64.186.161.108
The master_port (socket_port in the Master) will select which serial port is to be
connected to in the Slave boxes 1 and 2.
# telnet 64.186.161.108 80[01-32]
# ssh -l <username> -p [7097-7128] 64.186.161.108
CLI Method - Clustering
The clustering process is made using the ethernet interface, this means that no special
connection is needed between the boxes. All you need is to connect them in the same
physical network. To configure one ACS as master to control other ACS (slave), using
the CLI just follow the steps below:
Information for the approached example:
•
Master box - 4 port unit; 172.22.65.2 as IP address
•
Slave box - 32 port unit; 172.22.65.3 as IP address
•
Telnet protocol to access the serial ports.
Step 1 - Open the CLI interface by issuing the command:
# CLI
conf.eth_ip 192.168.170.4
conf.eth_mask 255.255.255.0
conf.eth_mtu 1500
#
# Local CAS serial ports (32 socket_ssh ports)
#
all.protocol socket_ssh
all.authtype local
all.ipno 192.168.170.101+
s[1-32].tty ttyS[1-32]
File Description 2.5: Slave2 box: /etc/portslave/pslave.conf