SAFETY WARNING
Potentially hazardous voltages exist on TELCO lines and associated equipment. Always
observe standard safety precautions during installation, operation and maintenance of
these products. To avoid the possibility of electric shock, be sure to disconnect the
power from the remote power source before you perform any line connections or repairs.
Always disconnect all the cables connected to the system before disconnecting the
grounding connection. After disconnecting the power allow a few seconds for the
internal capacitances to discharge before accessing the boards.
QUALIFIED PERSONNEL WARNING
The installation procedures described in this manual MUST be performed by qualified
personnel aware of the hazards involved. The personnel involved in equipment
installation must be trained in the installation of telephone equipment and associated
power systems; these personnel must strictly observe all the safety precautions related
to the installation of communication equipment. Never install, remove, or adjust
equipment and associated cables. Do not work on roofs, masts or towers during a
lightning storm.
ATTENTION! STATIC SENSITIVE DEVICES
PROPER HANDLING AND GROUNDING WARNING
Components within the Trailblazer system are sensitive to electrostatic discharge (ESD).
To avoid and prevent ESD damage, and device failure, maintain proper grounding
during configuration, repair or maintenance. This is achieved through the use of an
antistatic wrist strap securely connected to chassis ground. Do not use conductive tools
for adjusting channel select switch.
FCC, RF SAFETY HAZARD WARNING
Due to the energy radiated from the antenna, this product must never be mounted so
that the cabinet containing the antenna is closer than 2 meters (6.7 feet) to any person.
Refer to Section 4.2 for further restrictions.
UL INSTALLATION SAFETY INSTRUCTIONS
•
Never install telephone wiring during a lightning storm.
•
Never install telephone jacks in a wet location unless the jack is specifically
designed for wet locations.
•
Never touch telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
•
Use caution when installing or modifying telephone lines.
Connection to the Telephone Network
This equipment complies with Part 68 of the FCC rules. You will find the label located on
the device. This label contains the FCC Registration Number and the Ringer
Equivalence Number (REN) for the equipment. You must, upon request, provide this
information to your local telephone company. The REN is used to determine the
quantity of devices that may be connected to the telephone line and still have all of those
devices ring with an incoming call signal. In most areas the sum of the RENs of all
devices connected to one line should not exceed five (5.0). Confirm the number of
Trailblazer Installation and User Manual
iii
