Curtiss-Wright | Tritex II AC 90, 115 Rev. X PN39892 7/12/22
9
•
If used, the +24 VDC Control Logic power supply and/or the I/O
power supply must be a recognized or listed Class 2 Power
Supply
•
A secondary circuit intended to be supplied from a Class 2
transformer or power source in the field shall be marked “Class
2” next to the voltage rating of the device.
•
If used, optional input control power shall be 24 VDC, Class 2
supply or 24 VDC provided with a 4A fuse.
•
L1, L2, PE:
For input terminals maximum 14 AWG wire shall be
used but not less than 125% of the maximum current for the
input
.
•
Wires
ends
are to be solid for input terminal connections.
When
stranded wire is used
tin the wires or a similar method
should be
used to prevent
stray
strands of
wire
.
•
Do not strip wires more than 0.25 inch (6.3 mm) for input
terminal leads.
•
“Use copper conductors only”
for all power wiring.
•
Use UL approved copper only wires, 300 Vac minimum rating,
and 105º C minimum rating at input power and PE terminals
.
•
The Type 4 enclosure rating requires that the motor face plate is
attached to a similarly rated panel enclosure.
•
A ½ inch NPT connection with conduit is required to maintain
Type 4 enclosure rating. Teflon tape or equivalent must be used
to seal the NPT conduit to the housing.
Additional Information Related to UL
Motor Over temperature Sensing is not provided by the Drive
Though Tritex II AC has a high temperature limit switch built into the
motor, its overall function has not been approved by UL for motor over
temperature protection and is therefore not used as the basis for motor
overload protection.
Electronic Overload Protection
Solid state overload protection is provided in each model at no more
than 110% of rated output torque / force. This overload protection is
based on maximum continuous current capacity. It will allow up to 200 %
of rated output to be delivered for the amount of time determined by the
following chart:
Содержание EXLAR Tritex II AC
