Cupra BORN, Руководство пользователя

Страница: 308 / 343

Wheels and tyres Tyre repair
307
• Remove the bottle from the valve.
•
Replace the howitzer with the device
›››
Fig. 204
1
onto the tyre valve.
Inflating the tyre
• Screw the tyre inflation tube of the compres-
sor
›››
Fig. 204
8
on the tyre valve.
•
Check that the air evacuation screw is
closed
›››
Fig. 204
6
.
•
Connect the drive system.
•
Attach the connector
›››
Fig. 204
9
to the
vehicle’s 12 volt power outlet
›››
page 209 .
• Switch on the air compressor with ON/OFF
switch
›››
Fig. 204
5
.
•
Keep the air compressor running until it
reaches a pressure of 2.0-2.5 bar (29-36 psi/
200-250 kPa).
A maximum of 8 minutes .
•
Disconnect the air compressor.
• If it does not reach the pressure indicated,
unscrew the tyre inflator tube from the valve.
•
Move the vehicle 10m so that the sealant is
distributed throughout the tyre.
•
Screw the compressor tyre inflator into the
valve.
• Repeat the inflation process.
•
If it still does not come up to pressure, the
tyre is too badly damaged. Stop and seek assis-
tance from authorised personnel.
•
Disconnect the air compressor. Unscrew the
tyre inflation tube from the tyre valve.
• When the inflation pressure is between
2.0-2.5 bar, continue driving without exceed-
ing 80 km/h (50 mph).
•
Attach the sticker
›››
Fig. 204
2
to the in-
strument panel display, within the driver's field
of vision.
•
Check the pressure again after 10 minutes
›››
page 307 .
WARNING
When inflating the wheel, the air compressor
and the inflator tube may become hot.
• Protect hands and skin from hot parts.
•
Do not place the hot flexible inflator tube
or hot air compressor on flammable material.
•
Allow them to cool before storing the de-
vice.
• If it is not possible to inflate the tyre to at
least 2.0 bars (29 psi / 200 kPa), the tyre is
too badly damaged. The sealant is not in a
good condition to seal the tyre. Do not con-
tinue driving. Seek specialist assistance.
NOTICE
Switch off the air compressor after a maxi-
mum of 8 operational minutes to avoid over-
heating! Before switching on the air com-
pressor again, let it cool for several minutes.
Check after 10 minutes of driving
Screw in the inflator tube
›››
Fig. 204
5
again
and check the pressure on the gauge
6
.
1.3 bar (19 psi / 130 kPa) and lower:
• Stop the vehicle! The tyre cannot be sealed
sufficiently with the tyre mobility set.
•
You should obtain professional assistance
›››
.
1.4 bar (20 psi/140 kPa) and higher:
• Set the tyre pressure to the correct value
again.
• Carefully resume your journey until you
reach the nearest specialised workshop with-
out exceeding 80 km/h (50 mph).
• Have the damaged tyre replaced.
WARNING
Driving with an unsealed tyre is dangerous
and can cause accidents and serious injury.
•
Do not continue driving if the tyre pressure
is 1.3 bar (19 psi / 130 kPa) and lower.
•
Seek specialist assistance.