Cumberland PNEG-499, Инструкция по установке и эксплуатации

Страница: 43 / 64

PNEG-499 Cycle Plus Pan Feeder 43
6. Wiring Diagrams
External Wiring for Cycle Plus Pan Control (220 VAC 1 Phase)
Before inspecting or servicing the equipment, disconnect electrical power to the equipment, unless the
manual and maintenance instructions specifically state otherwise.
When installing the Cycle Plus Pan Feeder, wire the electrical equipment according to the wire diagrams
contained in this manual.
All electrical wiring in the field must be performed by a qualified electrician according to local and national
codes.
Do not operate the equipment without the covers and guards in their proper positions.
Failure to have covers and guards in their proper position may result in serious personal injury or
severe damage to the equipment.
Carefully ground all electrical equipment.
Figure 6A
Weigh Bin/
Fill System
Hopper
Fill System
No. 1
Feeders
Contactors
Feed Line Motor
Feed Line Motor
Control Panel Output:
230 Volt 1 Phase
To Hopper Fill System
To Weigh Bin Fill System
Ground
Upper
Lower
Momentary
Scale Switches
Cycle Plus Pan Control Panel