5. Installation
PNEG-499
Cycle Plus Pan Feeder
41
Programming the Cycle Plus Pan Feeder Control
Use the following step-by-step procedure to program the Cycle Plus Pan Feeder Control. The
programming procedure takes one function at a time and leads you through the steps that are required to
properly program the necessary information into that function. After each step, check the display to see
that it shows what is shown in the Display column of the programming procedure.
It is simple and easy to program the Cycle Plus Pan Feeder Control. The control cannot be damaged by
pushing the wrong button or buttons. Once a program had been entered into the control, the program will
not be affected by pushing any of the buttons unless the Modify button has been pressed first. Even if you
should accidentally push the Modify button and then push another button, only the information in the
illuminated function will be changed. That function can easily be reprogrammed. You do not have to be
afraid of this control. Try the different buttons and see what they are capable of doing.
Function
Step
Display
TIME
OF
DAY
1. Press
Time of Day
key
2. Press
Modify
key
3. Press
keys to set hours
4. Press
Enter
key
5. Press
keys to set minutes
6. Press
Enter
key
NOTE:
The AM/PM indicator on the right hand part of
the display indicates AM/PM. The DAY 1/DAY 2
indicator on the left indicates Day 1 or Day 2.
Time of Day
Flashing hours
Flashing minutes
Correct time
FEEDINGS
PER DAY
1. Press
Feedings per Day
key
2. Press
Modify
key
3. Press
keys to set number of feedings
4. Press
Enter
key
Number of feedings
Flashing number
Correct number of feedings
FEEDING
START
TIME
1. Press
Feeding Start Time
key
2. Press
keys until the feeding number time
you wish to alter is on display
3. Press
Modify
key
4. Press
keys to set hours
5. Press
Enter
key
6. Press
keys to set minutes
7. Press
Enter
key
Alternate flashing of feeding
number and the time of that
feeding
Alternate flashing of number
and starting time for feeding
Flashing hours
Flashing minutes
Alternate flashing of number
and correct starting time for
feeding
Содержание PNEG-499
