4. Pull the back panel (103) refer to identify the back panel (103) upward underneath the drive pipe
(50) and attach the hook and loop strips (99) in the back panel (103) to the hook and loop strips (99)
on the back plate (38).
NOTE:
Make sure to align the top and ends of curtain even with top and ends of hook and loop strip
(99) on the back plate (38).
5. Stretch the curtain taut and press the curtain firmly to secure.
NOTE:
Make sure that the strips (99) on the back panel (103) are aligned straight and matched up
to the strips (99) on the back plate (38) before installing the TEK screws (9).
6. Install self-tapping pan-head TEK screws (9) at 1"-2" from each end and evenly spaced at every 2'.
Tip
A magnetic 6" length phillips bit may be preferred to reach under the drive pipe (50) or install the
TEK screws (9) before the drive pipe (50) is installed. Also these TEK screws (9) should be installed
before the center (104) and front panels (102) are installed.
IMPORTANT:
TEK screws (9) which may accidently be dropped down inside the curtain panels
MUST BE REMOVED to prevent panel damage.
Figure 3-31
Attaching the back panel to back plate
38
Back plate
102
Front panel (hook and loop strip is located at the end of curtain roll)
50
Drive pipe
103
Back panel
99
Hook and loop strip
104
Center panel
4801-5405
Unitized System Komfort Kool
39
