CSZ Norm-o-Temp 111Z, Руководство по эксплуатации

Страница: 12 / 50

Operation Manual NORM-O-TEMP
®
, Model 111Z
Page 12 of 50
NORM-O-TEMP, Model 111Z
The NORM-O-TEMP ® , Model 111Z hyperthermia System is used to keep a patient comfortable
by maintaining blanket/pad water temperature through conductive heat transfer. The NORM-
O-TEMP
® hyperthermia system is composed of a heater, circulating pump, safety high limit, and
microprocessor board.
Distilled water is heated and pumped from the unit to a blanket/pad. The blanket/pad rests
under, around, and/or on top of the patient. The water circulates through the blanket/pad and
returns to the unit. When warmed water is circulated through the blanket/pad, the patient is
warmed. The unit is designed to operate based on the temperature of the circulating water.
The recommended blankets/pads for use are listed in Figure 8 Accessories.
1-3.
Physical Description of the NORM-O-TEMP
®
System
See Section 2 for specifications and certifications of the NORM-O-TEMP ® system.
1-3.1. External Features and Descriptions – Front View
The external features in Figure 1 of the NORM-O-TEMP
®
unit are described as follows:
A.
The control panel is composed of pressure sensitive touch switches and an LED display.
An expanded description of the membrane control panel is presented in Section 1-3.5.
B. The operating instructions printed below the control panel describe the necessary steps
to operate the unit.
C. The power switch is a bevel rocker switch labeled “I” (on) at the top and “O” (off) at the
bottom.
D. The four rubber feet help the unit to mount on the I.V. stand (Catalog #118), the low
profile stand (Catalog #119) or allow the unit to sit on a flat surface.
E. The water fill opening is where the operator pours distilled water to fill the reservoir.
F. The red, Power Fail LED is the visual indicator when power is disconnected with the
switch still in its on position or when the independent mechanical (High Limit) safety is
activated.