Crystal Vision
Using the front control panel
TANDEM 3G User Manual R1.4
31
23/04/2012
4 Using the front control panel
4.1 Module selected
This operational guide assumes that the panel has been set up according to the panel setup
procedure described in the Crystal Vision Control Panel manual.
Note:
It is
ESSENTIAL
that the panel set up procedure is followed and any old or unknown
passwords cleared prior to using the panel for the first time.
At power up all eight control panel keys LEDs will illuminate briefly. Once the panel has
completed its power up and configuration sequence the panel will enter Statesman mode and
the message ‘Press Cal to Exit’ will be displayed.
Statesman mode is entered by default
To continue with control panel operation or configuration, press the CAL key once. A second
press of the CAL key will return to Statesman control.
The control panel will display the name of the card that first responds to the polling request
together with its location number.
The location number consists of the frame number plus the card position in the frame.
Navigating the display
The functions assigned to control panel keys are:
DEVICE – enters Device menu to select a card or show cards available/enters
panel set up when held down during power up/shows frame status when pressed
from Statesman mode
CAL – enters or leaves Statesman mode/enters Panel Diagnostics mode when
held down during power up/updates the display
Asterisk – enters board rename menu from the Device menu (early RS422
panels only)
F1 to F4 – soft keys, function assigned within each menu
HOME – moves the display to the Home menu
ENTER – accept current selection
