Crystal Vision
Card edge operation
TANDEM 3G User Manual R1.4
28
23/04/2012
Preset location 1
Rotate the SCROLL/ADJ. control to show the preset save menu and
select the chosen location 1-16.
Press ENTER and rotate SCROLL/ADJ. to select SAVE or
RECALL.
Press ENTER to action a save or recall.
Preset location 16
Preset menu and factory reset
Up to 16 user-defined configurations may be stored and recalled either from the board control,
active front panel, Statesman or through the use of external GPIs. Presets store the board setup
data including operating mode card status. The presets are numbered 1-16.
Note:
Care should be taken when storing presets that the desired configuration is not changed by any external
input prior to saving.
Saving and recalling presets
The current board settings can be saved in one of 16 locations to be recalled as desired. This
allows the user to store and recall up to 16 different configurations for later use.
To save the current settings, select the preset location and press ENTER. Select the save
option and press ENTER to write the current settings into this location.
Note:
If the selected location contains previously saved setting information it will be over-
written by the new setting data.
To recall previously stored setting information, again choose the selected location and select
recall, pressing ENTER will recall the stored configuration.
The recalling of previously stored presets can also be implemented externally via the GPI port.
To use this facility, enable GPI control of presets.
Factory reset
The user has the choice of performing a total factory reset or a partial reset. Factory Reset will
return all parameters to their factory default values and erase all user-stored configuration
presets. Selecting the Defaults option will perform the same reset to factory defaults values but
will leave any user-stored configurations unaffected.
Note:
Factory reset will erase all user-stored presets
