Crystal Vision
Using card edge controls
TANDEM-300 User Manual R1.2
38
14/02/2008
Status/Config menus
SEL
No.
Description
Examples and comments
ADJ
funct
6
SD 1 de-embed
audio group
A=Agroup=
n
, where
n
is -(no group) or 1,2,3,4.
Shaft encoder changes value of
n
ADJ=
n
7
SD 2 de-embed
audio group
B=Bgroup=n, where n is -(no group) or 1,2,3,4.
Shaft encoder changes value of n
ADJ=
n
8
SD 1 embed audio
group
C=Agroup=n, where n is -(no group) or 1,2,3,4.
Shaft encoder changes value of n
ADJ=
n
9
SD 2 embed audio
group
Not supported by TANDEM-300
ADJ=
n
A
Audio bus settings
for audio monitor
AUDbus=OFF, ON or AUTO. Shaft encoder only
sets ON/OFF. AUTO set by remote panel
ADJ=
ON/OFF
B
Audio monitor
source
Selects stereo source for headphone socket and
rear audio monitoring bus if enabled
Amon = XX XX, where XX XX indicates the
stereo pair monitored
ADJ=
stereo pair
select
C
Audio delay C
1+2
Set using ADJ shaft encoder in 1ms steps from 1
– 681ms
ADJ=
delay
D
Audio delay C
3+4
Set using ADJ shaft encoder in 1ms steps from 1
– 681ms
ADJ=
delay
E
Silence threshold
Set using ADJ shaft encoder for the delay time in
seconds after which a channel is considered silent
(< -50dB wrt Full Scale). Available values start at
1.5s, 8s and then in increments of 8s until 120s
ADJ=
threshold
F
GPI
Enable/Disable
Disables General Purpose Inputs. General
Purpose Outputs (GPOs) are not disabled
ADJ=
disable
/enable
Note:
Remember that the ‘=’ sign before a group number indicates an existing group.
Audio routing is described in detail in section 8.4. Audio monitoring is described in
section 7.4 and GPI enable/disable options are described in section 7.3.
Warning:
For the first five SEL status positions the shaft encoder is not active and settings cannot
be changed, for SEL positions 6 to F, the shaft encoder will alter (but not save) the
assigned values as indicated in the remainder of the table. Do NOT touch the ADJ shaft
encoder when using these SEL positions for status information.
