Crystal Vision
Using card edge controls
TANDEM-300 User Manual R1.2
56
14/02/2008
6.13 Selecting the PLL mode
The PLL menu is obtained with MENU DIL, lever 3 ON (DOWN) and all other levers
UP (OFF
)
.
SEL
Display
Comments
2
PLL Off, 1 or 2
Select SDI PLL mode
Select the PLL mode from Off or Sdi 1 (Sdi 2 is not supported by TANDEM-300).
Note:
An explanation of the PLL function may be found in the Introduction and the
appropriate mode section of the Statesman chapter.
Menus for SEL positions 3 to F are not used or for factory use only.
6.14 Operating mode
TANDEM-300 does not support modes other than mode 1. For this reason the MODE
change function will be disabled. It is documented here for completeness only. The menu
is obtained with Menu lever 3 ON (DOWN) and all other levers UP (OFF
)
.
SEL
Display
Comments
0
MODE = 30X
Not supported by TANDEM-300 – do not use
1
SET MODE = X
Not supported by TANDEM-300 – do not use
6.15 Miscellaneous functions
Firmware version number
The TANDEM-300 firmware version number is obtained with MENU DIL, lever 6 ON
(DOWN), all other levers UP (OFF
)
and the SEL switch in position D.
SEL
Display
Comments
D
TANDEM 6.00
TANDEM firmware version number
Note:
Menu C and additional menus beyond D are for Crystal Vision engineering staff only.
