Crystal Vision
Using card edge controls
TANDEM-300 User Manual R1.2
37
14/02/2008
6.2 Card edge status menus
General Status Only menus
The SEL hex switch provides access to a range of status displays when the MENU DIL
levers are all OFF (UP). The available status-only displays (SEL positions 1-5) are
summarised in the following table:
SEL
No.
Description
Examples and comments
ADJ
funct
0
Auto
Display shows first three status menus (SEL
positions 1, 2 & 3) on a priority basis. Use this
setting when card edge controls are not in use.
N/A
1
SDI signal status
sdi = SDI present, -sdi = SDI not present
For example: C-sdiB sdi indicates that the SDI
input is absent and that the SDI input is present
N/A
2
AES & Ref I/P
status
(Note: if AIP or
AOP fitted
display is the
same as SEL 5)
If DIP fitted: Cas12
= Side 1 AES 1&2 channels present
Cas-2 = Side 1 AES 2 channel present only
Das34 = Side 2 AES 3&4 channels present
Cas2- Das-4 = AES 2 present on side 1 and AES
4 present on side 2
If DOP fitted: Aref1
= AES reference 1 present Aref- = AES
reference 1 absent Bref2 = AES
reference 2 present Aref1 Bref- = AES
reference present on side 1, but absent on side 2
N/A
3
Active de-embed
audio/silence
Shows active de-embed audio channels ‘s’ =
silence (> 50dB FS), number = active channel
12ss = Audio channels 1&2 active, 3&4 silent
(<50dB FS)
N/A
4
Active embed
audio/silence
As above for embed channels
N/A
5
Option cards
fitted
aip : AIP2 option card
aop: AOP2 option card
dip : DIP2 option card
dop7: DOP2-75 option card
dop1: DOP2-110 option card
RS2: DIP2RS option card
RS4: RS4 option card
N/A
Note:
For the above menus, the display is split between sides 1 and 2. The five left-most
characters refer to side 1 and the five right-most characters refer to side 2.
