Creo Trendsetter 3244+ AL, Руководство оператора

Страница: 87 / 134

Error Messages and Recommended Solutions 73
Focus error detected at
<distance> inches while
imaging
check plate for artifacts.
[Error #: 17664]
This error can be caused by:
•
dents in a plate
•
improperly loaded medium
•
an image running off the edge of the medium (that is, the
image is wider than the medium)
To correct the error:
1.
Inspect the medium closely for image artifacts.
2.
Try imaging again using a new medium of the correct
size.
Important: If the error persists, call your service
representative.
Incorrect light level at
start of edge detection.
Check plate if plate size
entered too small.
[Error #: 17731]
1.
Make sure the medium was loaded in the correct position
on the load ramp.
2.
Check the plate type information to ensure the medium
size stated in the workstation software matches the size
you loaded.
3.
If the medium sizes match:
In the Suspend dialog box on the workstation, click the
Resume
button to resume imaging.
Or:
If the medium sizes don’t match:
Click the
Cancel Image
button in the Suspend dialog box,
and modify the media size as needed.
Or:
Load a different-sized medium into the output device.
Or:
Reload the medium.
Error Category: Head
Error Message Recommended Operator Action