Creo Trendsetter 3244+ AL, Руководство оператора

Страница: 79 / 134

Error Messages and Recommended Solutions 65
Plate larger than expected.
Please remove plate.
[Error #: 15252]
The output device attempted to load a plate that was the
wrong size. When the output device determined that the
plate was the wrong size, it ejected it.
To correct the error:
1.
Remove the plate(s) in question from the output device.
2.
Load plates of the correct size onto the load table.
3.
Be sure the dimensions of the plates stacked on the load
table match the dimensions selected on the workstation.
4.
Resubmit the desired file from the workstation.
Plate loaded incorrectly,
remove plate from drum.
[Error #: 15062]
To correct the error:
1.
Open the front access panel.
2.
In the workstation software, click
Plate Removed
.
3.
Remove the plate from the drum.
4.
Close the front access panel.
5.
Check the workstation to confirm the plate size selected
matches the actual dimensions of the plate you’re
loading.
6.
Resubmit job and try again.
Plate smaller than expected.
Please remove plate.
[Error #: 15253]
The output device attempted to load a plate that was the
wrong size. When the output device determined that the
plate was the wrong size, it ejected it.
To correct the error:
1.
Remove the plate(s) in question from the output device.
2.
Load plates of the correct size onto the load table.
3.
Be sure the dimensions of the plates stacked on the load
table match the dimensions selected on the workstation.
4.
Resubmit the desired file from the workstation.
Error Category: Auto Loader (ALE)
Error Message Recommended Operator Action