Creo Trendsetter 3244+ AL, Руководство оператора

Страница: 47 / 134

Cleaning Exterior Surfaces 33
Removing Stains
To remove ink or other stains from the exterior surfaces of the output
device, wipe the stain away immediately with a cloth dampened with water
and mild dish detergent. If stains are persistent and do not come off with
mild detergent and water, use a sparing amount of acetone to remove the
stain.
Cleaning the Load Table and Manual Bypass Tray
Once a week, it is recommended that you clean the load table and manual
bypass tray with a clean, damp cloth.
To clean the load table and manual bypass tray:
1.
Dampen a clean cloth with water.
2.
Gently wipe the load table and manual bypass tray clean, leaving them
dry.
Figure 16: Load table and manual bypass tray
CAUTION: Avoid regular use of chemical cleaners, as these can damage the
exterior of the output device. Read and follow all directions provided by the
acetone manufacturer. Failure to do so can result in personal injury or damage to
the equipment.
CAUTION: Do not spray water directly on the load ramp or manual bypass tray,
as it could run into the interior of the output device and cause damage. Dampen
a cloth with water first, then wipe the surfaces clean.
Load table
Manual bypass tray