Creo Trendsetter 3244+ AL, Руководство оператора

Страница: 99 / 134

Image Quality Problems 85
4.
Slide the trailing-edge clamps up along the drum until they touch the
leading-edge clamps.
If the clamps have come off the drum, place them against the leading-
edge clamps.
a.
Ensure the
S
or
N
(magnetic polarity) on each clamp matches the
S
or
N
on the drum.
b.
Ensure the direction of the arrows on the clamps aligns with the
arrows on the drum.
5.
Verify that the trailing-edge clamps are evenly spaced.
The gaps between the trailing-edge clamps should be aligned with the
gaps in the leading-edge clamps above them.
6.
Verify that the trailing-edge clamps are installed in a straight line and
are parallel to and touching the leading-edge clamps.
7.
Verify that the trailing-edge clamp labels alternate between
S
and
N
.
8.
Close the front/top access panels.
See Opening and Closing the Front Access Panel on page 35 for more
information.
9.
Click the
Resume
button in the Suspend dialog box on the
workstation.
10.
If the output device suspends again with one of the following
messages, check the clamp alignment and adjust as necessary:
Timeout moving TE cylinder
TE failed to lock
TE clamps not on actuator/drum
Image Quality Problems
If you experience any image quality problems, call your service
representative immediately.