The Celeron™ Processor 3-5
Step 2: To mount the heat sink onto the Celeron processor
1. Assemble all parts on a static-free bench with proper operator
grounding and an ESD mat.
2. Carefully insert all four legs of the HS retention clip into the
Celeron processor.
The base of the HS retention clip must be located on the
non-primary side of the processor (see Figure 3-5).
The side of the clip which touches the substrate surface
on the processor is covered with a mylar insulator.
This insulator prevents the clip from shorting lines on
the substrate.
3. Remove the blue film covering the thermal interface.
The blue film protects the thermal interface from
damage during shipping.
Figure 3-5: Inserting the heat sink retention clip into the non-primary side of
the Celeron processor.
Содержание Blaster PC M001
Страница 1: ...TM M001 Motherboard...
Страница 3: ...ii...
Страница 14: ...The M001 Motherboard 1 5 Figure 1 1 The M001 motherboard...
Страница 67: ...Printed in Singapore...