Jumper Settings 5-5
For 66 MHz-based Pentium II/Celeron processors, 68 MHz, 75
MHz and 83 MHz are for overclocking the CPU bus.
For 100 MHz-based Pentium II processors, 103 MHz and 112
MHz are for overclocking the CPU bus. Generally,
overclocking the CPU bus is not a recommended practice.
To clear the CMOS
Under some unusual circumstances, the configuration record created
by the CMOS Setup utility can become corrupted and unusable. This
can cause the motherboard to stop functioning properly. In such cases,
you need to clear the CMOS record by using jumper JP6.
To clear the CMOS
1. Switch off the computer.
2. Remove the jumper cap from JP6 pins 1 and 2.
3. Place the jumper cap over JP6 pins 2 and 3 for two seconds.
4. Remove the jumper cap from pins 2 and 3.
5. Place the jumper cap back on pins 1 and 2.
Table 5-4: Jumper Settings for system frequency.
Processor Type
J201 Jumper
To force system frequency down for a 66
MHz-based processor
To let the system auto-detect a 66 MHz-based
processor
OR
To apply default system frequency for 100
MHz-based processors
Содержание Blaster PC M001
Страница 1: ...TM M001 Motherboard...
Страница 3: ...ii...
Страница 14: ...The M001 Motherboard 1 5 Figure 1 1 The M001 motherboard...
Страница 67: ...Printed in Singapore...