3-6 The Celeron™ Processor
4. Turn the processor around so that the primary side is now
facing the heat sink.
5. Insert the two left legs of the HS retention clip fully into the
heat sink (see Figure 3-6).
6. Hold the processor between the HS retention clip and the heat
sink.
Do not bend or apply pressure directly to the SEPP.
7. Use a non-metallic bar stock or screwdriver to push the
remaining two clip legs into the heat sink.
Do not allow the bar stock or screwdriver to come into
contact with the processor because the bar stock or
screwdriver may scratch the processor’s surface.
Figure 3-6: Inserting the left legs of the clip into the heat sink.
Содержание Blaster PC M001
Страница 1: ...TM M001 Motherboard...
Страница 3: ...ii...
Страница 14: ...The M001 Motherboard 1 5 Figure 1 1 The M001 motherboard...
Страница 67: ...Printed in Singapore...